Table of Contents
Advertisement
16.6 Monitor Setting
Use these screens to set up e-mail notification settings when certain conditions are met by the
managed devices and the Vantage CNM. You can customize who receives the e-mail
messages, what events you are notified of, and what the e-mail message contains.
You can also set the time interval when your Vantage CNM monitors the managed devices.
16.6.1 Notification Setting
Use this screen to set up e-mail notifications when the Vantage CNM detects certain
conditions on its managed devices.
Click Monitor > 3G Monitor > Monitor Setting > Notification Setting. The following
screen displays.
Figure 176 Monitor > 3G Monitor > Monitor Setting > Notification Setting
The following table describes the labels in this screen.
Table 147 Monitor > 3G Monitor > Monitor Setting > Notification Setting
LABEL
Notification trigger
events
Go to configure
notification content
Apply
Reset
Vantage CNM User's Guide
DESCRIPTION
Select the trigger events of which you want to be notified.
•
Signal strength is weaker than (value) dBm during (value) minutes
•
When over (value)% of time budget or (value)% of data budget
Primary/Backup WAN Fail-over
•
3G Card is not installed while 3G is enabled
Note that you can customize the value for signal strength. Specify the dBm
value and the length of time this state persists. The default values are -78
dBm and 1 minute.
You can also specify the time budget and data budget ratio. The default
value for both is 50.
Click this link to customize the notification message that you want to
receive from Vantage CNM.
Click this to save your settings.
Click this to change the settings in this screen to the last-saved values.
Chapter 16 3G Monitor
297
Advertisement
Table of Contents
Troubleshooting
