Configuring A Syslog Server; Figure 94 System Configuration: Syslog Setup: Add; Table 60 System Configuration: Syslog Setup: Add - ZyXEL Communications Version 1.03 User Manual

Table 59 System Configuration: Syslog Setup (continued)
LABEL
Syslog Server Setup
Index
Active
IP Address
Log Level
Add
Modify
Delete

13.5.1 Configuring a Syslog Server

You must specify a syslog server for the switch to send logs. In the Syslog Setup screen, click
Add to create a new syslog server entry or click Modify to edit an existing one.

Figure 94 System Configuration: Syslog Setup: Add

The following table describes the labels in this screen.

Table 60 System Configuration: Syslog Setup: Add

LABEL
Active
Server Address
Log Level
OK
Cancel
Clear
NetAtlas Workgroup User's Guide
DESCRIPTION
This field displays the index number.
This field indicates whether the syslog server setting is enabled or not.
This field displays the IP address of the syslog server.
This field displays the severity level of the logs which is to be stored on the
syslog server.
Click Add to configure a new syslog server.
Click Modify to change the settings of a selected syslog server.
Click Delete to remove the selected syslog server.
DESCRIPTION
Select Active to enable the settings of the syslog server.
Enter the IP address of a syslog server in dotted decimal notation.
Select the severity level of the logs to be stored on the syslog server.
Click OK to save the changes and close this screen.
Click Cancel to discard all changes and close this screen.
Click Clear to start configuring this screen again.
Chapter 13 System Configuration
137