Table of Contents
Advertisement
Chapter 5 Device Network Settings
Table 27 Device Operation > Device Configuration > Network > WAN > Dial Backup >
Advanced (ZyNOS ZyWALL) (continued)
LABEL
Drop DTR When
Hang Up
AT Response Strings
CLID
Called ID
Speed
Call Control
Dial Timeout (sec) Type a number of seconds for the device to try to set up an
Retry Count
Retry Interval
(sec)
Drop Timeout
(sec)
Call Back Delay
(sec)
Back
Apply
5.3.6 Edit Dial Backup (ZyNOS ZyWALL)
Click Edit in the TCP/IP Options field in the screen shown in
the next screen.4
98
DESCRIPTION
Select this check box to have the device drop the DTR (Data
Terminal Ready) signal after the "AT Command String: Drop" is
sent out.
Type the keyword that precedes the CLID (Calling Line
Identification) in the AT response string. This lets the device
capture the CLID in the AT response string that comes from the
WAN device. CLID is required for CLID authentication.
Type the keyword preceding the dialed number.
Type the keyword preceding the connection speed.
outgoing call before timing out (stopping).
Type a number of times for the device to retry a busy or no-
answer phone number before blacklisting the number.
Type a number of seconds for the device to wait before trying
another call after a call has failed. This applies before a phone
number is blacklisted.
Type the number of seconds for the device to wait before
dropping the DTR signal if it does not receive a positive
disconnect confirmation.
Type a number of seconds for the device to wait between
dropping a callback request call and dialing the corresponding
callback call.
Click this to return to the previous screen.
Click this to save your changes back to the device.
EXAMPLE
NMBR
CONNECT
60
0
10
20
15
Figure 41 on page 95
to display
Vantage CNM User's Guide
Advertisement
Table of Contents
Troubleshooting
