Image Of Link Scan And Link Refresh By Cyclic Transmission - Mitsubishi Electric L26CPU-BT User Manual

14.2
Image of Link Scan and Link Refresh by Cyclic
Transmission
The following shows a transmission image of link device remote input RX, remote output RY, and the remote registers
RWr and RWw.
1) Configure the link refresh of CC-Link IE Field Network in "Refresh Parameters" in Network Parameter of the CC-
Link IE Field Network master station. (Refer to
2) Configure the inter-device transfer settings of the head module by selecting "PLC Parameter" - "Operation Setting"
in the head module. (Refer to
3) Configure the CC-Link automatic refresh in Network Parameter of LJ61BT11, which is connected on the head
module. (Refer to
The head module link devices (RX/RY/RWr/RWw) are assigned as follows.
• Remote input (RX): Assigned from input (X0).
• Remote output (RY): Assigned from output (Y0).
• Remote register (RWr): Assigned from link register (W1000).
• Remote register (RWw): Assigned from link register (W0).
326
Page 330, Section 14.3.2 (2).)
Page 331, Section 14.3.2 (3).)
Page 328, Section 14.3.1 (3).)