Mitsubishi Electric L26CPU-BT User Manual page 216

(2) Operation error
In the following cases, operation error occurs; the error flag (SM0) turns ON and the error code is stored in SD0.
Error code
2112
4002
4003
4004
4100
4101
(3) Program example
When M6 is turned ON, 1-word data are written from the area starting D0 into the buffer memory address 111
the intelligent device station No.63 (AJ65BT-R2N), which is connected to the master module installed in the
position of I/O No. X/Y00 to X/Y1F.
The settings of the interlock signal storage device are as follows: request device RY4, completion device RX4,
error code storage device RWr1, and completion mode 1.
Also, set the link special register (SW) refresh device to SW0000.
M11 is the G(P).RISEND instruction executing flag.
214
When the module specified by Un is not an intelligent function module.
When the module specified by Un is not a special function module.
When an attempt was made to execute an unsupported instruction.
When the number of devices in the instruction is incorrect.
When the instruction specifies a device that cannot be used.
When the instruction contains the data that cannot be used.
When the number of data set to be used exceeds the allowable range.
Or, when the storage data or constants of the device specified with the instruction exceeds the
allowable range.
Performs processing for normal completion.
Performs processing for abnormal completion.
Description of operation error
Control data setting
Interlock signal storage
device setting
Sets data to be written to
intelligent device station
Dedicated instruction execution
Sets G(P).RISEND instruction
executing flag to ON.
Processing upon normal
completion of dedicated instruction
Processing upon failure of
dedicated instruction
Sets read request to OFF.
Sets G(P).RISEND instruction
executing flag to ON.
of
H