Table of Contents
Advertisement
(2) Interrupt Settings
Project window
1.
In the "Interrupt Settings" window, set the conditions on which the L series master/local module
issues the interrupt to a CPU module.
2.
Click the [End] button and close the setting window.
Item
Input Format
Device Code
Device No.
Detection Method
Interrupt Condition
Word Device Setting
Value
Channel No./Connection
No.
Interrupt (SI) No.
Only one interrupt condition can be set for one interrupt program.
104
[Parameter]
[Network Parameter]
Description
Select the input format of "Word Device Setting Value".
Set the device for the interrupt condition.
Select the timing of the interrupt detection for the device set in
"Device Code" and "Device No."
Set the word device value for the interrupt condition if RWr or
SW is set in "Device Code".
The setting is not required for an L series master/local module.
Set the interrupt (SI) No. used for the interrupt pointer setting of
the PLC parameter.
The interrupt (SI) No. is the control number on the L series
master/local module side to issue a request for the interrupt
from the L series master/local module to a CPU module. (This is
not a device used for an actual program.)
[CC-Link]
[Interrupt Settings] button
Setting range
• DEC
• HEX
(Default: DEC)
Refer to the following table on the next
page.
Advertisement
Table of Contents
Troubleshooting
