Table of Contents
Advertisement
(Setting range)
If the interrupt condition is established upon completion of a link scan, the interrupt is issued. If "Scan
Completed" is set in "Device Code", the interrupt is issued without condition upon completion of a link
scan.
Device
Device No.
Code
RX
0 to 1FFF(H)
Edge Detect + ON: Interrupt at rise
Edge Detect + OFF: Interrupt at fall
SB
0 to 01FF(H)
Level Detect + ON: Interrupt at ON
RY
0 to 1FFF(H)
Level Detect + OFF: Interrupt at OFF
RWr
0 to 07FF(H)
Edge Detect + Equal: Interrupt when the value is
matched (first time only)
Edge Detect + Unequal: Interrupt when the value is
not matched (first time only)
Level Detect + Equal: Interrupt when the value is
SW
0 to 01FF(H)
matched
Level Detect + Unequal: Interrupt when the value is
not matched
Scan
Completed
3.
When the interrupt settings are completed, open the "Intelligent Function Module Interrupt Pointer
Setting" window of the PLC parameter.
Relate "Interrupt (SI) No." of the L series master/local module set in the "Interrupt Settings" window to the
interrupt pointer of the CPU module.
Project window
button
4.
Input settings to the "Intelligent Function Module Interrupt Pointer Setting" window.
5.
Click the [End] button and close the setting window.
Detection Method
Condition
[Parameter]
[PLC Parameter]
Interrupt
Word Device
Setting Value
0 to 65535
(0(H) to
FFFF(H))
"PLC System" tab
CHAPTER 7 PARAMETER SETTINGS
Channel
Interrupt
No./Connection
(SI) No.
No.
0 to 15
[Interrupt Pointer Setting]
105
7
Advertisement
Table of Contents
Troubleshooting
