Mitsubishi Electric L26CPU-BT User Manual page 237

(j) In order to change the parameter setting method, turn the power supply to the
programmable controller system off and back on, or reset the programmable
controller CPU.
The following table shows how the programmable controller CPU operates when changing the parameter
setting method without turning the power supply to the programmable controller system off and back on, or
resetting the programmable controller CPU.
Parameter setting method
(before change)
Parameter setting with GX Works2
Parameter setting with the
G(P).RLPASET instruction
*1 Note that data link continues to be performed if the designation of operation at CPU down ((S1) + 5) of the
G(P).RLPASET instruction is set to "Continue."
(k) When the programmable controller CPU is switched from RUN to STOP, RY of the
master station and outputs to the device station are retained.
Parameter setting method
(after change)
Parameter setting with the
G(P).RLPASET instruction
Parameter setting with GX Works2
CHAPTER 9 DEDICATED INSTRUCTIONS AND PROGRAMMING
Error notification method
The G(P).RLPASET instruction
completes with an error.
LINK.PARA.ERR occurs in the
programmable controller CPU.
Continuity of data link
Data link continues.
*1
Data link stops.
235
9