Mitsubishi Electric L26CPU-BT User Manual page 281

CHAPTER 11 EXAMPLE OF COMMUNICATION BETWEEN THE MASTER STATION AND REMOTE DEVICE STATIONS
Set parameters as follows.
2.
Procedure registration of AJ65VBTCU-68DAVN
Click the "Regist Procedure" of the target station number "4".
The details to be set are as follows:
• Set channels 1 and 2 to Analog output enable. (the first condition)
• Set the output range of channel 1 to 0 - 5V, and channel 2 to User range setting 1.
(the second condition)
• Set the HOLD/CLEAR setting of channels 1, 2 to CLEAR.
(the third condition)
• Turn the Initial data processing completed flag to ON (the forth condition).
• Turn the Initial data setting request flag to ON (the fifth condition).
• Turn the Initial data processing completed flag to OFF (the sixth condition).
• Turn the Initial data setting request flag to OFF (the seventh condition).
Set parameters as follows.
The initial settings registered by using GX Works2 can be reflected to the remote device station by writing the settings to the
CPU module and turning on the remote device station initialization procedure registration instruction (SB000D). (Refer to
Page 169, Section 8.3.1 (4).)
11
279