Mitsubishi Electric L26CPU-BT User Manual page 139

Data link status
When a
The GX Works2 data
communication error
link faulty station is
(power off, etc.)
set (master station
occurs in a local
setting)
station
*1 If parameter setting has been made using the dedicated instructions, the data is held. If parameter setting has been
made using GX Works2, the data is cleared when the RY refresh device is set to Y, the data is cleared or held when the
RY refresh device is set to other than Y. (Refer to
*2 When the RY refresh device is set to "Y" for the local station that has stopped, only the receive area is cleared from the
stopped local station ; the receive area is retained or cleared when the RY refresh device is set to other than Y. (Refer to
Page 134, Section 8.2.5.)
Operation continues for the receive areas from other stations.
Master station, standby master station (acting as a
master station)
Remote
Remote
output
input (RX)
(RY)
Clears the
receive area
from the local
Clear
station with a
communication
error
Continue
Retains the
receive area
from the local
Hold
station with a
communication
error
Remote Remote
register register
(RWw) (RWr)
Retains the
receive area
from the local
Continue
station with a
communication
error
Page 134, Section 8.2.5.)
CHAPTER 8 FUNCTIONS
Remote I/O station
Input Output
Continue Continue
(Not affected (Not affected
by the by the
communication communication
status of the status of the
local station) local station)
137
8