9.1.9
G(P).RDMSG
This instruction reads/writes parameters from/to the remote device station and reads the status of the remote device
station.
Available for communication with a remote device station that supports the message transmission function (e.g.
NZ2AW1C2AL)
Set
Internal device
data
(System, user)
Bit
Word
(S1)
(S2)
(D1)
(D2)
[Instruction
[Execution
symbol]
condition]
G.RDMSG
GP.RDMSG
Set data
*1
Device
Start I/O number of the module
Un
(First 2 digits of I/O No. with three digits)
(S1)
Start number of the device in which control data is stored.
*2
Start number of the device that stores data to be sent.
(S2)
*2
Start number of the device that stores received data.
(D1)
Device that is turned ON for one scan upon completion of reading. (D2)
(D2)
+ 1 also turns ON at an abnormal completion.
*1
The file register of each of the local device and the program cannot be used as a device for setting data.
*2
For details of the send data and receive data, refer to the manual for the remote device station that supports the
message transmission function.
236
Link direct
device
File
J\
register
Bit
Word
Command
G.RDMSG
Command
GP.RDMSG
Description
Usable devices
Intelligent
function module
Index register
device
Z
U\G
Un
(S1)
(S2)
(S1)
(S2)
Un
Within the range of the
Within the range of the
Within the range of the
Within the range of the
Constant
K, H
$
(D1)
(D2)
(D1)
(D2)
Setting range
Data type
0 to FE
Binary 16 bits
H
specified device
Device name
specified device
specified device
specified device
Other
Bit