Mitsubishi Electric L26CPU-BT User Manual page 202

Control data
Device Item
(S1) + 0 Completion status
(S1) + 1 Station number
Access code
(S1) + 2
Attribute code
Buffer memory address
(S1) + 3
or device number
(S1) + 4 Number of points to write
*1 For details, refer to the manual for the local station or the intelligent device station to which data are written.
When the random access buffer is specified, specify the start address of the random access buffer as 0.
*2 The value indicates the maximum number of data to be written.
Specify the value within the buffer memory capacity of the local station or the intelligent device station, or the send buffer
area setting range set by a parameter.
*3 When writing device data to the programmable controller CPU other than the QCPU, LCPU, QnACPU or AnUCPU, the
setting range shall be 1 to 10 words.
200
Set data
Stores the status when the instruction is complete.
0: No error (normal completion)
Other than 0: Error code
Specify the station numbers of the master station, local station
and intelligent device station.
b15
Access code
Specify the buffer memory start address or device start number.
Specify the write data count (in word units).
b8 b7 b0
Attribute code
Setting range Set by

System
0 to 64 User
Page 201, Section
9.1.3 (1), Page
User
201, Section 9.1.3
(2)
*1
User
*2
1 to 480
User
*3
1 to 10