Mitsubishi Electric L26CPU-BT User Manual page 84

(1) Operation Setting
Project window
Item
Set the parameter name. (Even if the parameter name
Parameter Name is not set, this will not affect the operation of the CC-
Link system).
Select whether to clear or hold data input from a data
Data Link Faulty Station
link faulty station. (Refer to
Setting
8.2.4 and Page 136, Section 8.2.6.)
Select whether to refresh or clear compulsorily output
(sending) data to a device station when the switch on a
Case of CPU STOP
Setting
CPU module is set to STOP. (Refer to
134, Section 8.2.5 and Page 136, Section 8.2.6.)
Select whether or not to read the model name of device
stations with the connected device auto-detection
function.
Connected Devices
To read the model name of the device stations with the
Auto-detection Setting
connected device auto-detection function, refer to the
following.
Number of Occupied
The settings are not required when the L series
stations
master/local module is used as a master station.
Expanded Cyclic Setting
Select whether to assure the integrity of cyclic data for
Block Data Assurance
each device station. (Refer to
per Station
Section 8.2.9.)
82
[Parameter] [Network Parameter]
Description
Page 133, Section
iQ Sensor Solution Reference Manual
[CC-Link]
8 characters
(Default: Blank)
• Clear input data (not checked)
• Hold input data (checked)
(Default: Clear input data (not checked))
• Refresh (not checked)
• Clear compulsorily (checked)
Page
(Default: Refresh (not checked))
• Do not to read the model name of the device
stations (not checked)
• Read the model name of the device stations
(checked)
(Default: Do not to read the model name of the device
station (not checked)
• Disable setting (not checked)
• Enable setting (checked)
Page 159,
(Default: Disable setting (not checked))
[Operation Setting] button
Setting range
