Mitsubishi Electric L26CPU-BT User Manual page 53

When setting
parameters with GX Works2
Set the parameters with GX Works2.
(1) When remote net ver.1 mode is used
(2) When remote net ver.2 mode is used
(3) When remote net additional mode is used
(4) When remote I/O net mode is used
Register the parameters to the programmable
controller CPU.
Reset the programmable controller CPU or
power it OFF and then ON.
Check operation using the LEDs (master station):
When data link is normal: the "ERR." LED is off.
When data link is faulty: the "ERR." LED is lit or
flashing.
Check the connection status of each module
(loop test).
Check operation using the CC-Link diagnostics.
Register the control program in the programmable
controller CPU.
Reset the programmable controller CPU or power it
OFF and then ON.
*4 Page 72, CHAPTER 7
*5 Page 221, Section 9.1.8
*6 Page 67, Section 6.5
*7 Page 375, Section 15.4
Continued from the previous figure
Create a program in which the G(P).
RLPASET instruction is used.
*4
*4
*4
*4
Register PLC parameter/program to the
programmable controller CPU.
Reset the programmable controller CPU
or power it OFF and then ON.
Set the switch of the programmable controller
CPU to "RUN".
Off
On
or
*6
System operation
End
CHAPTER 4 PROCEDURE BEFORE OPERATION
When setting parameters
with dedicated instruction
*5
RUN/STOP/RESET
switch
Flashing
*7
4
51