Setting Details - Mitsubishi Electric L26CPU-BT User Manual

7.4.2

Setting details

Item
Select the number of the L series master/local modules.
Number of
Do not include the number of the L series master/local modules
Modules
that are set using the dedicated instruction (G(P).RLPASET).
Set the station
information in the
Checking this item is not necessary for a local station or standby
CC-Link
master station.
configuration
window
Set the start I/O number of the L series master/local module in
Start I/O No.
units of 16 points.
Set the operations to be performed upon an error or when the
Operation Setting
switch on a CPU module is set to STOP. (Refer to
103, Section 7.4.2 (1).)
Select "Local Station" to use the L series master/local module as a
local station. (Refer to
When only the standby master
station is started up, it starts
Type
data link as a master station.
Other than the above
*1 When selecting "Master Station (Duplex Function)", configure
the same settings as those of the master station. (Refer to
Station No. Set the station number.
Description
Page 140, Section 8.2.7.)
Operation
Master Station (Duplex
Function)
Standby Master Station
Page 77, Section 7.3.2.)
Varies depending on a CPU module. (Refer to
(Default: Blank)
Within the range of I/O points of the CPU module
(Default: Blank)
Page
Setting
• Master Station (Duplex Function)
• Local Station
*1
• Standby Master Station
(Default: Master Station)
• Local Station, Standby Master Station: 1 to 64
• Master Station (Duplex Function): 0 to 64
(Default: Blank)
CHAPTER 7 PARAMETER SETTINGS
Setting range
Page 72, Section 7.1.)


7
99