Mitsubishi Electric L26CPU-BT User Manual page 172

(5) Preparation for communication with remote device stations
1.
Register the network parameters and the created program in the programmable controller CPU.
2.
Reset the programmable controller CPU or power it off and then on.
3.
Instruct the master station to register the remote device station initialization procedure (SB000D).
(This instruction may not be necessary in some cases such as when the remote input RX is set as
a startup condition.)
● Because one step is performed per link scan, as the number of settings increases the processing time will extend beyond
that specified in the program.
● While the remote device station initialization procedure registration instruction (SB000D) is on, the refresh of the remote
input/output and remote registers stops.
● When the remote device station initialization procedure registration instruction (SB000D) turns OFF after completion of
the initial processing, all of RY signals that have turned ON during the initial processing turn OFF. Therefore, for signals
that should be kept ON (e.g. CH. Conversion enable flag of the AJ65BT-64RD3/4), turn them ON in the program.
● The remote device station initialization procedure registration completion status (SB005F) does not turn ON unless all of
initial processing for the stations specified in the remote device station initialization procedure registration station
specification (SW0014 to SW0017) is completed normally.
If any error station exists, turn OFF the remote device station initialization procedure registration instruction (SB000D)
depending on the status of the other stations.
● The remote device station initialization procedure registration is not allowed for the standby master station.
When replacing a remote device station while the standby master station is operating as a master, perform initial setting
on the program.
170