Mitsubishi Electric L26CPU-BT User Manual page 168

(a) In "Target Station No.", set the station number of the module for which the initial
settings are to be performed.
Setting range: 1 to 64
(b) Set the initial setting procedure in "Regist Procedure".
1.
Input format
Set the data input format for "Write Data" in details of execution.
Setting range:
Default:
2.
Execute Flag
Set whether or not to execute the specified initial setting procedure.
Setting range:
Default:
3.
Operational condition
Select whether to newly set the condition for the initial settings or use the previous condition.
Setting range: Set New
Default:
4.
Executional condition settings "Condition Device"
Set the device to be used for the initial setting operating condition.
Setting range: RX
5.
Executional condition settings "Device No."
Set the device number to be used for the initial setting operating condition.
Even if the target station number is different, the same number must be set.
Setting range: When RX is selected 0 to 37F (H)
166
DEC.
HEX.
DEC.
Execute
Only set (use as a memo when the execution conditions are the same as when the execution
flag is set as "Execute", but the content of execution is different.)
Execute
Same as Prev. Set
Set New
SB
When SB is selected 0 to FF (H)