Table of Contents
Advertisement
4
Tighten the screws.
5
Perform a color alignment adjust. See
Developer hold down removal
1
Remove the top cover. See
2
Remove the controller board shield. See
3
Remove the printhead. See
4
Pull the bell crank and spring off the mounting pin.
5
Pull the bell crank (B) and spring (C) off the mounting pin.
"Color alignment adjust" on page
"Top cover removal" on page
"Controller board shield removal" on page
"Printhead removal" on page
Parts removal
305.
397.
401
282.
392.
5028
Advertisement
Table of Contents
