Table of Contents
Advertisement
Action
Step 16
Reseat the sensor cable, and then check the sensor for
misalignment and damage.
Is the sensor properly installed and free of damage?
Step 17
Reinstall or replace the sensor. See
trailing edge) removal" on page
Does the problem remain?
Step 18
a
Enter the Diagnostics menu, and then navigate to:
Additional input tray diagnostics > Motor tests > Pick (tray [x])
b
Select a setting, and then touch Start.
Does the motor run?
Step 19
Reseat the motor cable, and then check the motor for misalignment
and damage.
Is the motor properly installed and free of damage?
Step 20
Reinstall or replace the motor. See
removal" on page
418.
Does the problem remain?
Step 21
Replace the media feeder. See
page
411.
Does the problem remain?
Step 22
a
Enter the Diagnostics menu, and then navigate to:
Additional input tray diagnostics > Sensor tests
b
Find the sensor (Pass-through (tray [x])).
Does the sensor status change while toggling the sensor?
Step 23
Reseat the sensor cable, and then check the sensor for
misalignment and damage.
Is the sensor properly installed and free of damage?
"Sensor (550-sheet tray
420.
"550‑sheet tray paper feeder
"Media feeder removal" on
Diagnostics and troubleshooting
162
Yes
Go to step 18.
Go to step 18.
Go to step 21.
Go to step 21.
Go to step 21.
Go to step 22.
Go to step 25.
Go to step 25.
5028
No
Go to step 17.
The problem is
solved.
Go to step 19.
Go to step 20.
The problem is
solved.
The problem is
solved.
Go to step 23.
Go to step 24.
Advertisement
Table of Contents
