Table of Contents
Advertisement
The following are the jumper configurations:
To set the jumpers:
1
Turn off the printer.
2
Remove the controller board shield. See
3
Remove the inner controller board shield. See
4
Locate the jumper connectors on the controller board.
5
Move the jumper of the motor being tested to the bypass position.
6
Press and hold the 3 and 6 buttons while turning on the printer to enter the Diagnostics menu.
7
Touch Printer diagnostics & adjustments > Motor tests.
8
Select a motor, and then touch Start.
9
After the test, turn off the printer, and then move the jumpers back to the default position.
Note: If the jumpers are not moved to the default position, then a false door open message appears
on the screen.
Interlock bypass disabled
(default)
Interlock bypass disabled
(default)
Interlock bypass enabled
Interlock bypass enabled
"Controller board shield removal" on page
"Inner controller board shield removal" on page
Service menus
277
5028
392.
393.
Advertisement
Table of Contents
