Table of Contents
Advertisement
10
Remove the rear right screw (H) from the printhead.
11
Remove the rear left screw (J) from the printhead.
Installation Notes:
1
When installing the printhead, replace the screws but do not tighten them right away. After installing the
screws, turn the printhead clockwise until it stops.
2
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments > Registration adjust > Quick test
3
If the printhead needs alignment, perform a printhead alignment adjust. See
adjustment" on page
297.
Parts removal
400
"Printhead alignment
5028
Advertisement
Table of Contents
