Table of Contents
Advertisement
5
Disconnect the sensor cable (B), and then remove the sensor.
Deskew rollers removal
Note: There are two types of deskew rollers used on this printer. The solid rubber roll use C-clips to fasten
the deskew roller. Printers using the segmented rubber roller use E-clips to fasten the deskew roller. The
parts are not interchangeable. Use both rollers when replacing this part.
1
Open the front door.
2
Remove the right cover. See
3
Remove the left cover. See
4
Remove the LVPS cage. See
5
Remove the sensor (media type). See
6
Remove the sensor (input). See
B
"Right cover removal" on page
"Left cover removal" on page
"LVPS cage removal" on page
"Sensor (media type) removal" on page
"Sensor (input) removal" on page
Parts removal
379
309.
308.
345.
377.
378.
5028
Advertisement
Table of Contents
