Table of Contents
Advertisement
Action
Step 5
Check the cable on the motor and on the JBOR1 connector on the
controller board for proper connection.
Is the cable properly connected at both ends?
Step 6
Reconnect the cable.
Does the problem remain?
Step 7
Check the cable for damage, and replace if necessary.
Does the problem remain?
Step 8
Replace the motor. See
page
346.
Does the problem remain?
Step 9
Replace the controller board. See
page
393.
Does the problem remain?
147 errors
147 error messages
Error code Description
147.80
The motor (deskew) did not turn on.
147.81
The motor (deskew) did not turn off.
147.82
The motor (deskew) speed did not ramp up to the
required level.
147.83
The motor (deskew) stalled.
147.84
The motor (deskew) ran too slow.
147.85
The motor (deskew) ran too fast.
147.86
The motor (deskew) did not run at the correct
timing.
"Motor (black only retract) removal" on
"Controller board removal" on
Diagnostics and troubleshooting
Yes
Go to step 7.
Go to step 7.
Go to step 8.
Go to step 9.
Contact the next
level of support.
Action
See
"Motor (deskew) service check" on
page
213.
212
5028
No
Go to step 6.
The problem is
solved.
The problem is
solved.
The problem is
solved.
The problem is
solved.
Advertisement
Table of Contents
