Table of Contents
Advertisement
Installing optional trays
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the controller board
or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off,
and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to
the printer, then turn them off as well, and unplug any cables going into the printer.
1. Turn off the printer.
2. Unplug the power cord from the electrical outlet, and then from the printer.
3. Unpack the optional tray, and then remove all packing material.
Note: If optional trays are already installed, then unlock them from the printer before lifting the printer. Do not
try to lift the printer and trays at the same time.
4. Align the printer with the optional tray, and then lower the printer until it clicks into place.
CAUTION—POTENTIAL INJURY: If the printer weight is greater than 20 kg (44 lb), then it may require
two or more people to lift it safely.
5. Connect the power cord to the printer, and then to the electrical outlet.
CAUTION—POTENTIAL INJURY: To avoid the risk of fire or electrical shock, connect the power cord to
an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.
6. Turn on the printer.
Add the tray in the print driver to make it available for print jobs. For more information, see
options in the print
driver.
MX-C507P [3] UPGRADING AND MIGRATING 3-13
Adding available
Advertisement
Table of Contents
