Table of Contents
Advertisement
149 errors
149 error messages
Error code Description
149.80
The motor (output) did not turn on.
149.81
The motor (output) did not turn off.
149.82
The motor (output) speed did not ramp up to the
required level.
149.83
The motor (output) stalled.
149.84
The motor (output) ran too slow.
149.85
The motor (output) ran too fast.
149.86
The motor (output) did not run at the correct
timing.
Motor (output) service check
Action
Step 1
Reset the printer.
Does the problem remain?
Step 2
Check the cable on the motor (output) and on the JOUTDC
connector on the controller board for proper connection and
damage, and replace if necessary.
Does the problem remain?
Step 3
Reset the printer.
Does the problem remain?
Step 4
Replace the motor. See
Does the problem remain?
Step 5
Reset the printer.
Does the problem remain?
"Motor (output) removal" on page
Diagnostics and troubleshooting
Action
"Motor (output) service check" on
See
page
214.
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 5.
334.
Go to step 6.
214
5028
No
The problem is
solved.
The problem is
solved.
The problem is
solved.
The problem is
solved.
The problem is
solved.
Advertisement
Table of Contents
