Table of Contents
Advertisement
Action
Step 10
Check the red cables connecting the JPKSNS1 connector to the
sensor (input) for proper connection and damage, and replace if
necessary.
Does the problem remain?
Step 11
Replace the sensor (input). See
page
378.
Does the problem remain?
Sensor (duplex/MPF input) service check
Action
Step 1
Check the error that appeared.
Is the error 100.35?
Step 2
a
Remove the cable cover from the front door.
b
Check if the cable is properly connected to the door and to the
JMSNS1 connector on the controller board.
Is the cable properly connected at both ends?
Step 3
Reconnect the cable.
Does the problem remain?
Step 4
Replace the cable.
Does the problem remain?
Step 5
Check the following sensors for proper connection, and reseat if
necessary:
•
Sensor (MPF empty)
•
Sensor (duplex path 1)
•
Sensor (fuser buckle)
•
Sensor (narrow media)
Does the problem remain?
"Sensor (input) removal" on
Diagnostics and troubleshooting
194
Yes
Go to step 11.
Contact the next
level of support.
Yes
Go to step 2.
Go to step 4.
Go to step 4.
Contact the next
level of support.
Go to step 6.
5028
No
The problem is
solved.
The problem is
solved.
No
Go to step 5.
Go to step 3.
The problem is
solved.
The problem is
solved.
The problem is
solved.
Advertisement
Table of Contents
