Configuring Voip Bandwidth Management Zones - Nortel 1000 Installation And Commissioning Manual

Page 406 of 466

Configuring VoIP bandwidth management zones

NN43041-310 Standard 01.11
Installing and configuring Nortel IP Phones
• Procedure 105: "Displaying registered IP Phones in Element Manager"
on page 436
Follow Procedure 93 to configure the VoIP bandwidth management zones.
For more details on bandwidth management zones, see IP Line: Description,
Installation, and Operation (NN43100-500).
VoIP bandwidth management zones can be configured with Element
Manager or using the CLI. For more information about Element Manager, see
Element Manager: System Administration (NN43001-632).
Procedure 93
Configuring VoIP bandwidth management zones using the CLI
1 Log in to the Call Server.
a. Enter the command:
LOGI
System response:
PASS?
b. Enter the default password:
0000
2 Access LD 117. Enter the command:
LD 117
3 Create a new zone with default parameters. Enter the command:
NEW ZONE 0
Note: LD 117 also includes DIS and ENL commands to disable or enable
a zone. When you create a zone, its default state is enabled. See
Table 53 on page 407
4 Print zone and bandwidth information. Enter the command:
PRT ZONE.
October 2008
for the LD 117 zone commands.