To Replace The Status Display Panel; Replacing The Status Display Panel - Nortel 1002rp Maintenance And Diagnostics

Replacing basic chassis components

Replacing the status display panel

The display is located at the front of the chassis and is cabled to the rear
of the chassis and the alarm board.

To replace the status display panel

.
1 Power off the server.
2 Remove the top cover and the front bezel from the chassis.
3 Remove the cooling fans (see "Replacing the cooling fan" on
page 126).
The cooling fans block the access to the status panel.
4 Loosen the four Phillips-head screws that secure the status display
panel to the front of the chassis (see A in Figure 26 on page 137)
136
CAUTION
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.
Standard 1.11
CallPilot