Canon imageRUNNER ADVANCE C5255 Series Service Manual page 941

COPIER > ADJUST > FEED-ADJ
ADJ-DK Paper Deck write start pstn in horz scan
Lv.1 Details To adjust the image write start position in the horizontal scanning
direction when feeding paper from the Paper Deck. (Paper width is
320 mm or smaller.)
As the value is incremented by 1, the margin on the left edge of
paper is increased by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the DC Controller PCB/clearing RAM data, enter the
value of service label.
Use case When replacing the DC Controller PCB/clearing RAM data
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Caution If the paper width is larger than 320 mm, execute mechanical
adjustment.
Display/adj/set range -50 to 50
Unit mm
Default value 0
ADJ-C1RE Write start pstn in horz scan: Cst1,2nd
Lv.1 Details To adjust the image write start position on the second side in the
horizontal scanning direction when feeding paper from the Cassette
1.
As the value is incremented by 1, the margin on the left edge of
paper is increased by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the DC Controller PCB/clearing RAM data, enter the
value of service label.
Use case When replacing the DC Controller PCB/clearing RAM data
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -55 to 55
Unit mm
Default value 0
8
Service Mode > COPIER > ADJUST > FEED-ADJ
8 Service Mode > COPIER > ADJUST > FEED-ADJ
COPIER > ADJUST > FEED-ADJ
ADJ-C2RE Write start pstn in horz scan: Cst2,2nd
Lv.1 Details To adjust the image write start position on the second side in the
horizontal scanning direction when feeding paper from the Cassette
2.
As the value is incremented by 1, the margin on the left edge of
paper is increased by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the DC Controller PCB/clearing RAM data, enter the
value of service label.
Use case When replacing the DC Controller PCB/clearing RAM data
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -55 to 55
Unit mm
Default value 0
ADJ-C3RE Write start pstn in horz scan: Cst3,2nd
Lv.1 Details To adjust the image write start position on the second side in the
horizontal scanning direction when feeding paper from the Cassette
3.
As the value is incremented by 1, the margin on the left edge of
paper is increased by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the DC Controller PCB/clearing RAM data, enter the
value of service label.
Use case When replacing the DC Controller PCB/clearing RAM data
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -55 to 55
Unit mm
Default value 0
8-121
8-121