Serial Interface Kit-K1/K2 / Copy Control Interface Kit-A1; Points To Note Before Installation; Checking The Contents; Check Items When Turning Off The Main Power - Canon imageRUNNER ADVANCE C5255 Series Service Manual

Serial Interface Kit-K1/K2 / Copy Control Interface
Kit-A1

Points to Note Before Installation

The following options cannot be used in combination with each other.
• Serial Interface Kit
• Copy Control Interface Kit
• Copy Card Reader

Checking the Contents

■ Copy Control Interface Kit-A1
CC-VI Cable X 1 [2] D-SUB Support Plate
[1]
X 1
[4] Hexagonal Screw (Washer (Small) ,Nut) X 2
Do not use a Nut
9
Installation > Serial Interface Kit-K1/K2 / Copy Control Interface Kit-A1 > Check Items when Turning OFF the Main Power
■ Serial Intreface Kit-K1/K2
Washer (large) X 2
[3]
[5] IA Harness Protection
Sheet X 1
F-9-312
Check that the main power switch is OFF.
1) Turn OFF the main power switch of the host machine.
2) Be sure that display in the Control Panel and the lamp of the main power supply are turned
off, then disconnect the power plug.
9 Installation > Serial Interface Kit-K1/K2 / Copy Control Interface Kit-A1 > Check Items when Turning OFF the Main Power
[1] Serial RS Conversion [2] IA Harness Protection
Board X 1 Sheet X 1
[4] Hexagonal Screw X 2 [5] Washer X 2
[7] Support Plate X 1 [8] RS Conversion
Cable (Long) X 1
K2 only K2 only

Check Items when Turning OFF the Main Power

9-119
[3] RS Conversion
Cable X 1
[6] PCB Spacer X 1
[9] Screw (TP; M3x6) X 3
K2 only
F-9-313
9-119