Canon imageRUNNER ADVANCE C5255 Series Service Manual page 477

4
Parts Replacement and Cleaning > Image Formation System > Removing the Hopper (M) > Procedure
2) While avoiding the duct sheet, remove the Hopper Unit.
• 1 connector
• 4 screws
Connector
Hopper
Unit
x2
Duct Sheet
4 Parts Replacement and Cleaning > Image Formation System > Removing the Hopper (M) > Procedure
x2
F-4-264
CAUTION:
If it is placed sideways, toner may scatter inside the Hopper and it may cause the
operation failure. Thus, stand and put the Hopper Unit on the paper.
Paper
CAUTION:
Before installing the hopper to the host machine, be sure to check that the leading edge
of the protrusion of the Bottle Fixing Ring and the leading edge of the Bottle Fixing Arm
are aligned. If not, rotate the gear in the direction as shown in the figure below to align
the leading edge of the protrusion of the Bottle Fixing Ring with the leading edge of the
Bottle Fixing Arm.
Gear
Bottle Fixing Ring
4-157
F-4-265
Bottle Fixing Arm
F-4-266
4-157