Canon imageRUNNER ADVANCE C5255 Series Service Manual page 1317

11) Place the Signal Cable (80 mm; Blue) (FK2-8438 or A: HDD-Sig2) and the Power
Cable (80 mm) (FK2-8461 or A: HDD-Pow1/2) to the empty space of the second HDD (Slot
2).
12) Fix the cables with the wire saddle.
9
Installation > [TYPE-6] > Installing the LED Board > Installing the Encryption Board
Signal Cable
Ppower Cable
F-9-658
Wire Saddle
F-9-659
9 Installation > [TYPE-6] > Installing the LED Board > Installing the Encryption Board
CAUTION:
• Be sure to place the tags on the Power Supply Cable in the position where it is
beyond the wire saddle toward the HDD side.
• If returning the Controller Box while placing the cables and tags toward the PCB side,
they may interfere the fan on the host machine.
Wire Saddle
13) Close the HDD Lid. (1 Screw)
14) Place the Controller Box to the original position. (2 Screws or 3 Screws)
15) Install the removed cover and the cable.
• Rear Cover (2 Screws, 2 Rubber Caps)
• Left Rear Sub Cover (1 Screw)
• Reader Communication Cable (when reader is installed)
• Left Rear Cover (2 Screws, 2 Rubber Caps)
16) If Reader is installed, install the Reader Power Cable.
NOTE:
Handle the Reader Power Cable from the connector side and make a slack at [A] part.
Bend the Reader Power Cable at a right angle on [B] part.
9-247
Tag
F-9-660
9-247