Installing Other Parts - Canon imageRUNNER ADVANCE C5255 Series Service Manual

■ Lead-edge Margin Adjustment (2nd side)
1) Make 2-sided copy from cassette 1, and check that the lead-edge margin on the 2nd side is L1 = 4.0
+1.5/-1.0 mm. If the lead-edge margin is out of the specification, go through the following steps to
make adjustment.
Feeding direction
of paper
2) Select the following in Service Mode (Level 1) : COPIER > ADJUST > FEED-ADJ > REG-
DUP1
3) Change the setting value to make adjustment (1 increment of the setting value reduces the
lead-edge margin by 0.1mm)
4) To make the setting value effective, turn OFF/ON the main power of the Host Machine.
5) Write down the new adjustment value on the service label.
• REG-DUP1
9
Installation > Installation Procedure > Installing Other Parts
L1
image
F-9-74
9 Installation > Installation Procedure > Installing Other Parts

Installing Other Parts

<Service Book Holder>
1) Remove the double-stick tape detachment paper on the rib area of the Service Book
Holder, and attach the Service Book Holder to the Pedestal Bottom Plate.
CAUTION: Do not attach the Service Book Case to the following location:
• Inside the machine (inner side of the front cover)
• Anywhere that blocks the louver area
• Anywhere that blocks the grip area
NOTE:
In the case of machine confifuration without the cassette pedestal, attach the Service
Book Case to the Left Cover of this main unit.
9-35
F-9-75
9-35