3) Install the Conversion Connector.
CAUTION:
Make sure that there is no opening between the Conversion Connector and part of
HDD.
9
Installation > [TYPE-8] > Installation Procedure > Disassembling/Assembling and Installing the HDD Removed from the Host Machine (First HDD)
4) Fit the 2 bosses of Connector Fixing Block to the hole of Conversion Connector and install
it.
• 2 Screws (P Tight; M3x8)
CAUTION:
• Be sure to firmly hold the Connector Fixation Block when tightening the screws.
• Be sure to follow the correct order to tighten the screws, otherwise the Conversion
F-9-738
9
Installation > [TYPE-8] > Installation Procedure > Disassembling/Assembling and Installing the HDD Removed from the Host Machine (First HDD)
Connector may not be connected properly, resulting in poor contact.
x2
9-277
F-9-739
Boss
Hole
F-9-740
9-277