Canon imageRUNNER ADVANCE C5255 Series Service Manual page 1283

3) Connect the LED Cable (1200 mm; 7-pin) (FM4-0839 or A: LED-Sig).
• 7 Wire Saddles
• 1 Edge Saddle
• 1 Cable Guide
• 1 Connector
CAUTION:
• Be sure to tuck the [A] area of the LED cable under the other 2 cables running
through the [A] area. This is to prevent the [A] area of the LED cable from being
slacked off when closing the Controller Box.
Wire Saddle Cable Guide
x8
Connector Edge Saddle Wire Saddle
9
Installation > [TYPE-4] > Installation Procedure > Installing the Mirroring Board or Encryption Board
Wire Saddle
(Top side of the Controller Box）
[A]
LED Cable
(1200mm; 7 pin)
F-9-571
9 Installation > [TYPE-4] > Installation Procedure > Installing the Mirroring Board or Encryption Board
■ Installing the Mirroring Board or Encryption Board
1) Install the Mirroring Board or Encryption Board so that "CHA" and "CHB" are placed in the
direction of the HDD slot.
• 4 Screws (TP; M3x6)
CAUTION:
Be sure that the direction of installing the Mirroring Board or Encryption Board is
opposite to the case when the Removable HDD is installed. If it is installed in a wrong
direction, the cables do not reach the board.
x4
9-213
Direction of the HDD Slot
F-9-572
9-213