Installing The System Software Using The Sst; Checking The Security Version; Checking The Security Mark; Checking After Installation - Canon imageRUNNER ADVANCE C5255 Series Service Manual

Installing the System Software Using the SST

The system data stored on the HDD and used to control the host machine will be lost when
the machine is first started up after installing this product.
It is important to install the system software used to control the host machine so that the
machine may start up properly after installation of this product.
Details follow.
1. Requirements
1) PC
Service support tool in the version that supports this host machine must be installed.
2) Cross Ethernet Cable
2. Preparing for the Installation of the System Software of Host machine
1) If both PC and the machine are on, turn them off.
2) Connect the PC and the machine using an Ethernet cable.
3) Turn on the PC.
4) Start up the machine in download mode (safe mode).
3. Selecting the System Software
1) Set the CD containing the latest system software in the PC on which the SST is used.
2) Start up the SST.
3) Click Register Firmware.
4) Select the drive in which the System Software CD has been set, and click search.
5) Click REGISTER.
6) Click OK.
4. Downloading the System Software
1) Click "Start Assist Mode" and click "Initialize" according to the instruction on the screen.
2) When initialization is completed, the machine is automatically restarted and it enters
download mode.
3) Select the version to be downloaded and click "Start".
4) When download is completed, the machine is automatically restarted.
5) When writing of the firmware is completed, the machine is automatically restarted.
6) Perform upgrading according to the instruction on the screen. When it is completed, it is
automatically restarted.
7) Terminate the SST.
8) Check the version of the downloaded firmware in service mode.
9
Installation > [TYPE-10] > Checking after Installation

Checking the Security Version

1) Press the Counter key (123 key) on the control panel.
2) Press the [Check Device Configuration] key appearing on the control panel.
3) Make sure that '2.00' or '2.01' is displayed in 'Canon MFP Security Chip' as version
information of the security chip.
When several Encryption Boards are installed, multiple version information is displayed.
CAUTION:
The user will be able to make sure that the encryption board fitted with a security chip
of the correct version with CC authentication is functioning normally by referring to the
version information indicated for 'Canon MFP Security Chip'.

Checking the Security Mark

The user may check the security mark, appearing on the control panel when using the Host
machine to make sure that an appropriate level of security is being maintained.
The mark appears when the machine is equipped with an encryption board and the board is
operating correctly.
The Users Guide provides the following description in connection with the security mark:
<Confirming the Security Mark>
When the HDD Data Encryption & Mirroring Kit is operating normally, a security mark(
is displayed on the lower left corner of a panel screen.

Checking after Installation

1) Make sure that the LED blinks.
• HDD1 (Slot 2): The green LED blinks.
9 Installation > [TYPE-10] > Checking after Installation
9-327
)
9-327