Function - Canon imageRUNNER ADVANCE C5255 Series Service Manual

SORTER > ADJUST
THN-STCL Poor stack prev mode: l-ppr, thin paper
Lv.1 Details To set poor stack prevention mode for large paper and thin paper.
Use case When large paper and thin paper are not appropriately stacked
Adj/set/operate method Select the item to be highlighted, set the value, and then press OK
key.
Caution This mode is available only with the External Finisher.
Display/adj/set range 0 to 1
Default value 0
CLCT-SB Adjusting the switchback amount
Lv.1 Details Adjust the switchback amount when the paper is delivered to the
processing tray.
Use case When the paper stack fault occurs at the processing tray by influence
of the curl amount.
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range -50 to 50
Unit mm
Default value 0
DSTP-F1 Adjusting the front staple position in 2-stapling mode
Lv.1 Details Adjust the front staple position in the middle 2-stapling mode.
Incrementing the value by 1 shifts the front stapling position to the
paper edge side by 0.1 mm.
Use case When the middle 2-staple position is displaced between the front and
rear stapling positions.
Adj/set/operate method After inputting value, press the OK key.
Display/adj/set range 0 to 33
Default value 0
8
Service Mode > SORTER > FUNCTION
T-8-88
8 Service Mode > SORTER > FUNCTION

FUNCTION

SORTER > FUNCTION
FIN-CON Controller PCB RAM clear: Fin-C1
Lv.1 Details To execute the RAM clear of Finisher Controller PCB to delete all the
adjustment contents and counter information.
Adj/set/operate method 1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution - Output the service mode setting values by P-PRINT before
execution. After execution, enter necessary setting value.
- The RAM data is cleared after the main power switch is turned
OFF/ON.
Display/adj/set range None
Related service mode COPIER> FUNCTION> MISC-P> P-PRINT
8-247
T-8-89
8-247