Settings To Enable "Access Management System" (North/Middle/South America And Europe Only) - Canon imageRUNNER ADVANCE C5255 Series Service Manual

■ Checking Network Function on the Main Controller
Check with the loopback address:
Select: [Settings/Registration] > [Preferences] > [Network] > [TCP/IP Settings] > [IPv4
Settings] > [PING Command], and enter the IP address "127.0.0.1" with the numeric keypad
and press the Execute key.
If the display shows "Response from the host", the network of the main controller is properly
functioning.
If the display shows "No response from the host", the network function of the main controller
is faulty.
Replace with a main controller that works properly, and the check connection.
9
Installation > Installation Procedure > Settings to enable "Access Management System" (North/Middle/South America and Europe only)
Settings to enable "Access Management System"
(North/Middle/South America and Europe only)
This setting needs to be made to enable Access Management System.
Upon user's request, make this setting.
Press Counter button, and check that "ACCESS MANAGEMENT SYSTEM" is displayed on
[Check Device Configuration] screen. If it is displayed, there is no need to make this setting.
<Checking method>
CAUTION:
Even if the setting is changed, "ACCESS MANAGEMENT SYSTEM" is not displayed on
[Check Device Configuration] screen if SSO-H has not been selected as login service.
1) Press Counter button, and check the controller version displayed on [Check Device
Configuration] screen.
• The version is "16XX.XXXX.XXX*" or earlier: Go to "Setting method in service mode"
• The version is "1700.XXXX.XXX*" or later: Go to "Setting method from Settings/
Registration"
* "XXXX" differs according to the environment.
<Setting method in service mode>
1) Enter service mode (Level 1), and set the setting value to "0".
• COPIER > OPTION > FNC-SW > AMSOFFSW
2) Turn OFF and then ON the main power.
3) Press Counter button, and then check that "ACCESS MANAGEMENT SYSTEM" is
displayed on [Check Device Configuration] screen.
<Setting method from Settings/Registration>
1) Select Settings/Registration > [Management Settings] > [License/Other] > [Use ACCESS
MANAGEMENT SYSTEM].
2) Select [ON], and then press [OK].
3) Turn OFF and then ON the main power.
4) Press Counter button, and then check that "ACCESS MANAGEMENT SYSTEM" is
displayed on [Check Device Configuration] screen.
9 Installation > Installation Procedure > Settings to enable "Access Management System" (North/Middle/South America and Europe only)
9-40
9-40