Canon imageRUNNER ADVANCE C5255 Series Service Manual page 1395

CAUTION:
• When fixing the cables with wire saddles, be sure to take up slack of them at [A] part,
and slack off them at [B] part.
• If slacking off the cables at [A] part, they may interfere the fan on the host machine
when returning the Controller Box.
[B]
9
Installation > [TYPE-10] > Installing the Encryption Board
[A]
Wire Saddles
F-9-873
9 Installation > [TYPE-10] > Installing the Encryption Board
CAUTION:
Be sure to acknowledge the following caution before performing the next procedure.
Combinations of connection between the HDDs and the Encryption Board are shown
below.
Keep Slot 1 in the condition where no HDD is installed, and only connect the cables.
• Connect Slot 1 to "CHB".
• Connect Slot 2 to "CHA".
Power Cable
Signal Cable(Blue)
Power Cable
CH A
CH B
Signal Cable(Red)
9) Connect the cable of the HDD Drawer Unit to the Encryption Board.
x4
9-325
Slot.2 (HDD1)
Slot.1 (Blank)
F-9-874
Power Cable
from front side
Signal Cable(Blue)
Signal Cable(Red)
Power Cable
from rear side
F-9-875
9-325