Checking After Installation - Canon imageRUNNER ADVANCE C5255 Series Service Manual

5) Hold the grip and remove the Main Controller PCB 2.
• 2 Screws
x2
Grip
6) Install the Expansion RAM.
9
Installation > Additional Memory Type D (512MB) > Checking after Installation
7) Install the Main Controller PCB 2.
CAUTION:
• Lift the grip and insert the Main Controller PCB 2. When it touches the end, tilt the
• Make sure to tilt the grip slowly on both sides simultaneously.
• Check that the Main Controller PCB 2 is installed properly.
F-9-297
8) Install the removed cover and the cable.
• Connect the FAX cable (If the FAX is installed.)
• Left Rear Sub Cover (2 Screws)
• Reader Communication Cable (if the Reader is installed).
• Left Reader Cover (2 Screws, 2 Rubber Caps)
9) Connect the power plug of the host machine to the power outlet.
10)
F-9-298

Checking after Installation

1) After adding the Expansion RAM, check that the memory capacity is increased.
• Service mode (level 1) > COPIER > DISAPLAY > ACC-STS > RAM
2) Exit the service mode.
9 Installation > Additional Memory Type D (512MB) > Checking after Installation
grip and install it with 2 screws.
x2
Turn ON the main power switch.
9-114
Grip
F-9-299
9-114