Canon imageRUNNER ADVANCE C5255 Series Service Manual page 988

COPIER > OPTION > NETWORK
SSLMODE Setting of HTTP/HTTPS port open/close
Lv.2 Details To set whether to open or close HTTP/HTTPS port.
When 1 is set while [Use HTTP] is ON and [SSL Settings] is OFF in
Settings/Registration menu, HTTP port is opened whereas HTTPS
port is closed.
When 2 is set while both [Use HTTP] and [SSL Settings] are ON in
Settings/Registration menu, HTTP port is closed whereas HTTPS port
is opened.
Use case When limiting the port to open because of security concern
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 2
0: Normal, 1: Open HTTP port (80/8000) only, 2: Open HTTPS port
(443/8443) only
Default value 0
Related UI menu Preferences> Network> TCP/IP Settings> Use HTTP
Management Settings> License/Other> MEAP Settings> SSL Settings
SSLSTRNG Allow weak encryption algorithm for SSL
Lv.2 Details To set whether to allow using weak encryption algorithm for SSL.
When 1 is set, weak encryption algorithm cannot be used.
Use case When prohibiting weak encryption algorithm because of security
concern
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 1
0: Normal mode, 1: Secure mode (Not used TLS_RSA_WITH_
RC4_128_SHA, TLS_RSA_WITH_RC4_128_MD5)
Default value 0
RAWTOUT Set of reception timeout at printing
Lv.2 Details To set the duration of time before disconnecting the connection when
packet reception is delayed during printing with RAW/LPR setting.
If connection is not disconnected after making prints from a Windows
PC via network, failure such as unable to make print from other
devices occurs. In such case, shorten the timeout time so that
connection is disconnected earlier.
Use case When failure (unable to make print, etc.) occurs on the network where
a Windows PC is connected
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 1 to 5
1: 1 minute, 2: 3 minutes, 3: 5 minutes, 4: 10 minutes, 5: 60 minutes
Unit min
Default value 5
RAW-PORT [For customization]
8
Service Mode > COPIER > OPTION > NETWORK
8 Service Mode > COPIER > OPTION > NETWORK
COPIER > OPTION > NETWORK
SSL30 ON/OFF of SSL 3.0
Lv.2 Details To set whether to use SSL 3.0 with the installed machine.
Set the value to 0 when not using SSL 3.0 because of security
concern.
Use case Upon user's request
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 5
8-168
T-8-52
8-168