Canon imageRUNNER ADVANCE C5255 Series Service Manual page 450

4
Parts Replacement and Cleaning > Image Formation System > Reinstalling the ITB > Actions after Replacement
CAUTION:
• When replacing ITB with a new one, after installing the ITB Cleaning Unit to the ITB
Unit, apply tospearl on the whole area indicated in the figure below.
• When applying tospearl, be careful not to scatter it on inside of the ITB, the Drive
Roller and the Secondary Transfer Inner Roller.
• If it is scattered on inside of the ITB, the Drive Roller or the Secondary Transfer Inner
Roller, wipe it with lint-free paper moistened with alcohol while rotating the motor by
hand. At this time, turn the motor counterclockwise and do not turn it clockwise.
4 Parts Replacement and Cleaning > Image Formation System > Reinstalling the ITB > Actions after Replacement
CAUTION:
When replacing ITB with a new one, affix the label to the specific position near the
Waste Toner Ejection Mouth of the ITB Cleaning Unit after the ITB Unit is installed.
When affixing the new label, be sure to remove the old label and replace with the new
one on the same position.
■ Actions after Replacement
1) Turn ON the power of the host machine.
2) When the machine is in standby condition, execute the following in user mode: (Settings/
Registration > Adjustment/Maintenance > Adjust Image Quality > Auto Adjust Gradation).
4-130
4-130