Installing the LED Board
1) Install the LED Board (small) (FK2-7400 or A: LED).
• 2 Screws (TP; M3x6)
x2
2) Install the 2 wire saddles and the edge saddle.
Edge Saddle
9
Installation > [TYPE-6] > Installing the LED Board
F-9-647
Wire Saddles
F-9-648
9
Installation > [TYPE-6] > Installing the LED Board
3) Connect the LED Cable (1200 mm; 7-pin) (FM4-0839 or A: LED-Sig).
• 7 Wire Saddles
• 1 Edge Saddle
• 1 Cable Guide
• 1 Connector
CAUTION:
• Be sure to tuck the [A] area of the LED cable under the other 2 cables running
through the [A] area. This is to prevent the [A] area of the LED cable from being
slacked off when closing the Controller Box.
Wire Saddle
Cable Guide
x8
Connector
Edge Saddle
Wire Saddle
9-243
Wire Saddle
(Top side of the Controller Box)
[A]
LED Cable
(1200mm; 7 pin)
F-9-649
9-243