Canon imageRUNNER ADVANCE C5255 Series Service Manual page 1285

6) Install the Ring Core to the Power Supply Cable as shown in the figure.
7) Fix the cables.
• 3 Wire Saddles
NOTE:
Be sure to close the unused 2 wire saddles [A] and edge saddle.
x4
Wire Saddle
9
Installation > [TYPE-4] > Installation Procedure > Installing the Mirroring Board or Encryption Board
Wire Saddle
Wire Saddle [A]
Edge Saddle
F-9-575
9 Installation > [TYPE-4] > Installation Procedure > Installing the Mirroring Board or Encryption Board
CAUTION:
Be sure to acknowledge the following caution before performing the next procedure.
Combinations of connection between the HDDs and the Mirroring Board or Encryption
Board are shown below.
• Connect Slot 1 to "CHA". (Originally installed HDD)
• Connect Slot 2 to "CHB". (New HDD)
Slot.2 (HDD2)
Slot.1 (HDD1)
8) Connect the Signal Cable (80 mm; Red) (FK2-8436 or A: HDD-Sig1) and the Power Cable
(80 mm) (FK2-8461 or A: HDD-Pow1/2) to CHA on the Mirroring Board or Encryption
Board.
x2
9-215
Signal Cable(Blue)
Power Cable
Signal Cable(Red)
Power Cable
F-9-576
Signal Ccable
Power Cable
F-9-577
9-215