Canon imageRUNNER ADVANCE C5255 Series Service Manual page 1409

■ Assembling and Installing the Option HDD
1) Purchase option HDD and assemble the second HDD.
• 1 Option HDD (enclosed with option HDD)
• 1 HDD Support Plate (enclosed with option HDD)
• 1 HDD Connector Plate (enclosed with removable HDD Kit)
• 4 Vibration-prevention Dumpers (enclosed with option HDD)
• 4 Spacers (enclosed with option HDD)
• 4 Screws (W sems; M3x14) (enclosed with option HDD)
NOTE:
When tightening the screen, be sure to align the screw holes by lifting the HDD
Connector Plate and HDD.
Anti-vibration Damper
x4
9
Installation > [TYPE-11] > Installing the Removable HDD Kit > Assembling and Installing the Option HDD
HDD HDD Support Plate
HDD Connector Plate
F-9-907
Option HDD
HDD Connector Plate
HDD Support Plate
Spacer
Vibration-prevention Dumpe
F-9-908
9 Installation > [TYPE-11] > Installing the Removable HDD Kit > Assembling and Installing the Option HDD
CAUTION:
• Assembling the option HDD, be careful of the installation direction.
• Make sure that the label on the option HDD is facing up.
• Install it in the position where the HDD connector is placed in the side with screw
hole of HDD Support Plate. (opposite direction compared to the fixed HDD)
Label
2) Affix the gasket to the place shown in the figure below.
CAUTION:
Be sure to place the gasket in contact with the label-free metal surface of the HDD
surface.
Gasket
Connector side
HDD
9-339
Screw hole
Connector
Screw hole
F-9-909
Screw hole
F-9-910
9-339