Canon imageRUNNER ADVANCE C5255 Series Service Manual page 1346

■ Disassembling/Assembling and Installing the HDD Removed
from the Host Machine (First HDD)
1) Remove the HDD from the HDD Support Plate. (Use the HDD (160GB) removed in
"Removing the HDD Unit, Signal Cable and Power Supply Cable" step 17.)
• 4 Screws
x4
2) Install the HDD Connector Plate first, and then HDD to the HDD Support Plate. (Use the
HDD and screws removed in previous step.)
• 4 Screws
NOTE:
When tightening the screen, be sure to align the screw holes by lifting the HDD
Connector Plate and HDD.
Anti-vibration Damper
9
Installation > [TYPE-8] > Installation Procedure > Disassembling/Assembling and Installing the HDD Removed from the Host Machine (First HDD)
HDD
HDD Support Plate
F-9-734
HDD HDD Support Plate
HDD Connector Plate
F-9-735
9 Installation > [TYPE-8] > Installation Procedure > Disassembling/Assembling and Installing the HDD Removed from the Host Machine (First HDD)
x4
CAUTION:
• Assembling the option HDD, be careful of the installation direction.
• Make sure that the label on the option HDD is facing up.
• Install it in the position where the HDD connector is placed in the side with screw
hole of HDD Support Plate. (opposite direction compared to the fixed HDD)
Label
9-276
HDD
HDD Connector Plate
HDD Support Plate
F-9-736
Screw hole
Connector
Screw hole
F-9-737
9-276