Canon imageRUNNER ADVANCE C5255 Series Service Manual page 1265

14) Remove the Signal Cable and the Power Cable. (Removed Signal Cable and Power
Cable will not be used.)
<When the Cable Cover is removed>
• 2 Edge Saddles
• 6 Wire Saddles
• 2 Connectors
x2
x8
Signal Cable
Power Cable
<When the Cable Cover is not removed>
• 2 Edge Saddles
• 5 Wire Saddles
• 2 Connectors
x2
x7
Signal Cable
Power Cable
9
Installation > [TYPE-3] > Installation Procedure > Removing the HDD Unit, Signal Cable and Power Supply Cable
Wire Saddle
Connector
Edge Saddle
Wire Saddle
Edge Saddle
Wire Saddle
Connector
Edge Saddle
Edge Saddle
Wire Saddle
9 Installation > [TYPE-3] > Installation Procedure > Removing the HDD Unit, Signal Cable and Power Supply Cable
<When the Cable Cover is removed>
15) Remove the 2 Wire Saddles. (Removed wire saddles will not be used.)
16) Remove the HDD Unit by holding it as shown in the figure below. (Removed HDD unit
F-9-513
will not be used.)
• 2 Screws (Removed screw will not be used.)
x2
F-9-514
9-195
F-9-515
F-9-516
9-195