Installing The Led Board - Canon imageRUNNER ADVANCE C5255 Series Service Manual

Installing the LED Board

1) Install the LED Board (small) (FK2-7400 or A: LED).
• 2 Screws (TP; M3x6)
x2
2) Install the 2 wire saddles and the edge saddle.
Edge Saddle
9
Installation > [TYPE-10] > Installing the LED Board
F-9-865
Wire Saddles
F-9-866
9 Installation > [TYPE-10] > Installing the LED Board
3) Connect the LED Cable (1200 mm; 7-pin) (FM4-0839 or A: LED-Sig).
• 7 Wire Saddles
• 1 Edge Saddle
• 1 Cable Guide
• 1 Connector
CAUTION:
Be sure to tuck the [A] area of the LED cable under the other 2 cables running through
the [A] area. This is to prevent the [A] area of the LED cable from being slacked off
when closing the Controller Box.
Wire Saddle Cable Guide
x8
Connector Edge Saddle Wire Saddle
9-322
Wire Saddle
(Top side of the Controller Box）
[A]
LED Cable
(1200mm; 7 pin)
F-9-867
9-322