Removing The Hopper (Y) - Canon imageRUNNER ADVANCE C5255 Series Service Manual

4
Parts Replacement and Cleaning > Image Formation System > Removing the Hopper (Y) > Procedure
CAUTION:
When installing the Toner Tray, align the Rod Lever with the Toner Cover Open/Close
Rod Lever and install it.
Toner Cover
Open/Close Rod Lever
Rod Lever
CAUTION:
When installing the removed Toner Container, be sure not to shake it.
CAUTION:
When the Main Drive Unit is removed simultaneously, make sure to install the Main
Drive Unit first and then, the Hopper Unit in order. Otherwise, toner supply failure may
occur.
■ Actions after Replacement
When replacing the Developing Assembly, make sure to initialize before installing the Toner
Container.
COPIER > FUNCTION > INSTALL > INISET-M
If install the Toner Container before initialization, T/D ratio cannot set the right value.
4 Parts Replacement and Cleaning > Image Formation System > Removing the Hopper (Y) > Procedure

Removing the Hopper (Y)

■ Preparations
1) Release the lock of Toner Container. (By service mode)
2) Open the Front Cover, the Right Lower Cover and Right Upper Cover.(Refer to page 4-104)
3) Remove the ITB Unit.(Refer to page 4-105)
4) Remove the Process Unit.(Refer to page 4-132)
5) Remove the Color Drum Heater. (When the option is installed)(Refer to page 1-1)
6) Remove the Toner Container Front Inner Cover.(Refer to page 4-154)
■ Procedure
1) Remove the Toner Tray.
• 1 screw (M4 binding)
F-4-267
4-158
F-4-268
4-158