Checking The Security Mark (Only When Installing Hdd Data Encryption & Mirroring Kit); Setting The Mirroring; Reporting To The System Administrator At The End Of The Work (Only When Installing Hdd Data Encryption & Mirroring Kit); Execution Of Auto Adjust Gradation (Only When Installing Hdd Data Encryption & Mirroring Kit) - Canon imageRUNNER ADVANCE C5255 Series Service Manual

Checking the Security Mark (Only when installing HDD
Data Encryption & Mirroring Kit)
The user may check the security mark, appearing on the control panel when using the Host
machine to make sure that an appropriate level of security is being maintained.
The mark appears when the machine is equipped with an encryption board and the board is
operating correctly.
The Users Guide provides the following description in connection with the security mark:
<Confirming the Security Mark>
When the HDD Data Encryption & Mirroring Kit is operating normally, a security mark(
is displayed on the lower left corner of a panel screen.

Setting the Mirroring

1) Insert the power plug into the socket and turn on the main power of the host machine.
2) Make a setting of mirroring.
• Specify "1" under "Service Mode > COPIER > OPTION > FNC-SW > W/RAID".
3) Turn OFF/ON the main power of the host machine to enable the setting value.
4) Make sure that the UI screen is activated correctly.
5) Make sure that the LED blinks.
• HDD1 (Slot 1): The green LED blinks.
• HDD2 (Slot 2): The green and red LEDs blink.
CAUTION:
Rebuild process starts after setting "1" for W/RAID. If an error occurs during the rebuild
process at the initial installation The hard disk needs to be replaced. (Call service rep.),
reexecute the process with the following procedure.
1) Check that the lighting red LED is HDD2.
2) Select Service Mode > COPIER > OPTION > FNC-SW > W/RAID, and set "0".
3) To enable the setting value, turn OFF/ON the Main Power Supply Switch of the host
machine.
4) Select Service Mode > COPIER > OPTION > FNC-SW > W/RAID, and set "1".
5) To enable the setting value, turn OFF/ON the Main Power Supply Switch of the host
machine.
The foregoing procedure is limited to the rebuild process at the initial installation.
An error during the rebuild process that is executed during operation is not included in
the consideration.
9
Installation > [TYPE-4] > Execution of Auto Adjust Gradation (Only when installing HDD Data Encryption & Mirroring Kit)
Reporting to the System Administrator at the End of
the Work (Only when installing HDD Data Encryption &
Mirroring Kit)
When you have completed all installation work, report to the system administrator for the
following:
At the point when installation is completed, make explanations about how to check that
the appropriate security function has been added and enabled so that, when the function
becomes uncontrolled, the system administrator can immediately detect the problem and
request <servicing work when a failure occurs>.
)
Completion of the Installation Work:
Ask the system administrator to make sure that '2.00' or '2.01' is indicated for 'Canon MFP
Security Chip' as the version information of the security chip by referring to the description
of Checking the Security Version.
Maintenance of the Security Functions:
Ask the system administrator to check the security mark to make sure that the security
functions are maintained each time the machine is started up by referring to the description
of Checking the Security Mark.
Execution of Auto Adjust Gradation (Only when
installing HDD Data Encryption & Mirroring Kit)
When this product is installed, the machine initializes its HDD, resetting the data used for
auto gradation adjustment.
Therefore be sure to execute auto gradation adjustment (full adjust) after installing this kit.
9 Installation > [TYPE-4] > Execution of Auto Adjust Gradation (Only when installing HDD Data Encryption & Mirroring Kit)
9-219
9-219